X1 BANDE COURTE PUNISHER

X1 bande adhésive.

Chacune des bandes mesure 30cm
La largeur totale est de 6.5cm
La largeur d'une bande est de 3cm
L'espace entre les deux est de 5mm.



Livré sous transfert.

Finition brillante par défaut.

The dimensions for each sticker are specified in the description above.

Colors are to be chosen from the options above.

For further customization , please do not hesitate to contact us via the contact form before ordering.

Before starting, make sure that the surfaces are smooth and perfectly degreased (even if the vehicle is new or recently repainted)

How to prepare the body?

• A good cleaning with water and a NON-shiny shampoo is necessary.

WARNING: Do not use WD40, white spirit, shine shampoo, polish, Vulcanet wipes... and other products with silicone.

Read the 3 mistakes to avoid...

THE STEPS:

1. Clean and scrub
2. Rinse with clean water
3. Don't forget the fairing corners and returns. Some stickers can go that far.
4. Dry thoroughly

• It is important that the surface is not at too low a temperature; in winter, remember to heat the surface a little during installation using a heat gun.

• If the stickers are not applied immediately, store them in a dry place away from sunlight and heat.

• After application, avoid contact with cold and humidity for the first few days to optimize hold.

Motorcycle stickers are products made to order.

Therefore, returns, exchanges and refunds are not possible.

It is then important to check your order carefully and follow our application advice.