Stickers Intérieur jante BMW S1000XR

X4 Stickers S1000XR
Spécial Intérieur de jante


Déjà courbé, vous pouvez les former pendant la pose très facilement si cela est nécessaire afin de les adapter à la taille de vos jantes.

Autocollants livrés sous transfert.
Finition brillante par défaut.

Tous nos stickers peuvent être vernis.

The color is to be chosen from the options above.

CHANGES

For more customization, you can contact us by email before your order. Remember to be as specific as possible so that the request is processed quickly.

Before starting, make sure that the surfaces are smooth and perfectly degreased (even if the vehicle is new or recently repainted)

How to prepare your rims?

• A good cleaning with water and NON-shine shampoo is necessary.

WARNING: Do not use WD40, white spirit, polishing shampoo, Vulcanet wipes... and other products with silicone.

Read the 3 mistakes to avoid...

THE STEPS:

1. Clean and scrub
2. Rinse thoroughly
3. Repeat the operation if necessary with F gasoline for example in order to eliminate all traces of grease, polish, etc.
4. Rinse
5. Dry perfectly

OUR ADVICE +

• It is important that the surface is not at too low a temperature. In winter, work preferably indoors, heated, and remember to heat the surface a little during installation using a heat gun.

• If the stickers are not applied immediately, store them in a dry place away from sunlight and heat.

• After application, avoid contact with cold and humidity for the first few days to optimize hold.

You will receive the rim stickers in a waterproof envelope.

Preparing the stickers

• First of all you will need to separate each sticker with scissors.
• Remove the excess around the sticker: make a cut as close as possible to the sticker (2-3mm) to facilitate positioning.
• On a table, pass the squeegee vigorously over each of the stickers, in order to re-grasp a little of the transfer adhesion which could have moved during transport.

APPLICATION OF STICKERS

1. DETERMINE EACH LOCATION

Without gluing them, place them on the rim in order to choose the location of each one. You can also decide to place them differently if you like.

2. START PASTING

Once the location is decided, start by peeling off the backing paper in one corner.

All you should have left is the sticker and its semi-transparent transfer.

Press this assembly with your fingers following the edge of the rim, to use it as a guide.

When the sticker is completely stuck, pass the squeegee (or a plastic card) over it firmly.

Then remove the transfer, carefully, by pulling from one corner and back, flat on the rim. If in some places, the sticker comes with it, then stick it back on and press firmly again, this will separate them.

OUR ADVICE +

• It is important to keep the surface at the correct temperature. A surface that is too cold will not allow the stickers to stick. In winter, work preferably indoors, and remember to heat the surface a little during installation using a heat gun.

• If the stickers are not applied immediately, store them in a dry place away from sunlight and heat.

• After application, avoid contact with cold and humidity for the first few days to optimize hold.

On this product PRSmotorsport guarantees you the free return of some elements if you fail to install them.

TERMS :

1. Provide us with a photo of the problem encountered
2. Make the request within 30 days after the delivery date

Rim stickers are made-to-order products.

Therefore, returns, exchanges and refunds are not possible.

It is then important to check your order carefully.