COVERING CARBONE 4D

Before starting, make sure that the surfaces are smooth and perfectly degreased (even if the vehicle is new or recently repainted)

How to prepare the body?

• A good cleaning with water and a NON-shiny shampoo is necessary.

WARNING: Do not use WD40, white spirit, shine shampoo, polish, Vulcanet wipes... and other products with silicone.

THE STEPS:

1. Clean and scrub
2. Rinse with clean water
3. Don't forget the corners and bodywork returns.
4. Dry perfectly

Read the 3 mistakes to avoid...

SOME ADVICE

• It is important that the surface and the covering roll are not at too low a temperature; in winter, remember to heat the surface a little during installation using a heat gun.
• If the stickers are not applied immediately, store them in a dry place away from sunlight and heat.
• After application, avoid contact with cold and humidity for the first few days to optimize hold.

Special covering vinyls are products tested and approved before being put on sale.

However, we cannot control the conditions of implementation by the customer.

Therefore, returns, exchanges and refunds are not possible in the event of a poor result.

It is then important to follow the application instructions.