LISERETS jante SUZUKI DOT

Ces liserets de jantes sont vendus par défaut en 17"

Le kit comprend : (pour les 2 roues)

+ 8 liserets courbés adaptables à vos jantes
+ 8 liserets "SUZUKI" pour bord de jante
Soit 4 liserets et 4 stickers par jante.



Tous nos stickers peuvent être vernis.

LES COULEURS 1 et 2 sont à choisir dans les options ci-dessus.

Quelle est la couleur 1 ?
Les correspondances des couleurs sont indiquées sur la photo démo du produit en question.

CHANGES

For more customization, you can contact us by email before your order. Remember to be as specific as possible so that the request is processed quickly.

Before starting, make sure that the surfaces are smooth and perfectly degreased (even if the vehicle is new or recently repainted)

How to prepare your rims?

• A good cleaning with water and NON-shine shampoo is necessary.

WARNING: Do not use WD40, white spirit, polishing shampoo, Vulcanet wipes... and other products with silicone.

Read the 3 mistakes to avoid...

THE STEPS:

1. Clean and scrub
2. Rinse thoroughly
3. Repeat the operation if necessary to remove any traces of polish, for example.
4. Dry thoroughly

OUR ADVICE +

• It is important that the surface is not at too low a temperature. In winter, work indoors, preferably heated, and remember to heat the surface a little during installation using a heat gun.

• If the stickers are not applied immediately, store them in a dry place away from sunlight and heat.

• After application, avoid contact with cold and humidity for the first few days to optimize hold.

You will receive the rim stickers in a waterproof envelope.

Preparing the stickers

• First of all, you will need to separate each element of the decoration kit with scissors.
• Differentiate between the stickers that will go on the rear rim and those that will go on the front rim (the dimensions of the rim interior elements may change)
• On a table, pass the squeegee vigorously over each of the stickers, in order to re-grasp a little of the transfer adhesion which could have moved during transport.

APPLICATION OF STICKERS

1. DETERMINE EACH LOCATION

Without gluing them, place them on the rim to check that the spaces between each one are correct. You can also decide to place them differently if you like.

2. START PASTING

Once the location is decided, start by peeling off the backing paper in one corner.

All you should have left is the sticker and its semi-transparent transfer.

Press this assembly with your fingers following the edge of the rim, to use it as a guide.

When the sticker is completely stuck, pass the squeegee (or a plastic card) over it firmly.

Then remove the transfer, carefully, by pulling from one corner and back, flat on the rim. If in some places, the sticker comes with it, then stick it back on and press firmly again, this will separate them.

OUR ADVICE +

• It is important to keep the surface at the correct temperature. A surface that is too cold will not allow the stickers to stick. In winter, work preferably indoors, and remember to heat the surface a little during installation using a heat gun.

• If the stickers are not applied immediately, store them in a dry place away from sunlight and heat.

• After application, avoid contact with cold and humidity for the first few days to optimize hold.

On this product PRSmotorsport guarantees you the free return of some elements if you fail to install them.

TERMS :

1. Provide us with a photo of the problem encountered
2. Make the request within 30 days after the delivery date

The rim decoration kits are products made to order.

Therefore, returns, exchanges and refunds are not possible.

It is then important to check your order carefully.